FlagTrax hanging hardware

FlagTrax hanging hardware are among the best advertising tools to grab attention wherever they are displayed. 

light pole banner bracket are a great way to showcase a message whether it's a temporary, seasonal or all year campaign. light pole banner bracket remain popular for their visibility.

Thank you for choosing the FlagTrax hanging hardware system.This product is designed to be installed by qualified technicians and instructions below are intended as a guide only.

Please read thoroughly before attempting installation.

These instructions are for the installation of FlagTrax hanging hardware with a FlagTrax hanging hardware top supporter bracket to poles(steel or concrete).This FlagTrax hanging hardware model is designed to use stainless steel banding to fix the track to the lighting stand,lamppost or pole.

Each FlagTrax hanging hardware installation requires the following components:

Supplied:

×1 FlagTrax hanging hardware top curve track with 2 Arm Adapters and nuts and bolts to tighten once the arm is in place

×1 FlagTrax hanging hardware bottom track with tapped holes for flag tensioner(s)

×1,×2 or no middle tracks depending on models

×1 Plastic PushPull Rod

×1 FlagTrax hanging hardware Top Supporter Bracket with 1 Allen Wrench

×1 Right Flag Tensioner with cap screw and spring washer pre-installed

×2 FlagTrax hanging hardware Key

×1 Locking Cap for PushPull Rod

×2 A 64 D rivets per track for tracks assembly

Bracket can be raised and lowered/bracket can lift

Easy to change the advertising banner

Instructions:

      The surface where the bracket will be inatalled is what will determine the type of screws that should be used.Please make sure to get a professional’s recommendation before installation.We recommend that you pre-drill holes on the track before installation.For the straight track(s),there should be 3 holes:one 8’’ from the bottom,one 8’’ from the top and one in the middle of the track (36’’ from top or bottom).For the top curved track,there should be two holes:one 8’’ and one 26.5’’ from the bottom of the track.

     Assemble the bracket before putting it up by riveting all the tracks with the provided rivets.

Track spacers must be used at every drilled hole to avoid damaging the track.Once the top support bracket is installed,slide the assembled track into it using the adapters.When fitted,tighten them.Fasten the bracket Track from top to bottom to the support with appropriate screws.

Builter is the FlagTrax hanging hardware manufacturer in China for 7 years.We have applied the patents for our FlagTrax hanging hardware which we designed.And we have offered lots of FlagTrax hanging hardware to Europe countries,Iran,Nigeria.and etc.it can resist for 8-class storm. This is the big difference from other kind of FlagTrax hanging hardware.